Tag: DIY

Motion control camera crane improvements completed

sad moment here at PETA plasmas it’s time to remove this yeah I’m a Twitter now that I have space I will set up the slider with a volley so we’ll be doing a little of motion control in this project this is a slider in the camera head and the crane one day I […]

Read More

How to Replace a Lawn Tractor Tire ~ Rick’s Tips

Hey Everybody Rick here this week I’m going to show you how to change a very worn out tire on my lawn tractor that I got for free a few years ago It’s very worn out time to go So we’re now upgrade to a new one using basic tools and minimum work environment in […]

Read More

Installing a loader valve on my Massey 50

it’s Pete from cheap homesteading and I’m in the garage this morning and I really have to get the valve on my Massey 50 tractor I just got to get it on if I don’t get it on now I’m not gonna have time and then we won’t get the full benefit from the equipment […]

Read More

Rebuilding Tractor Hydraulic Cylinders

Today on Mike attempts, rebuilding hydraulic cylinders. One of the hydraulic cylinders for the front-end loader on my Ford 860 tractor was leaking pretty bad but, while I’m at it, I might as well rebuild both of them. Start by removing the cap, luckily mine was only hand tightened. There are tools to remove and […]

Read More

Frugal Camera Crane / Jib 2.0

everyone welcome to the frugal crane two point no upgrade episode the approval rating the kramer built by you’re going to group use of the parts to solve some issues the biggest one being will this work with that is our camera in the past are said to say no but they i can see […]

Read More

Workshop Crane powered by DRILL

Przekładnia planetarna 1:100 Łożyska i tak były zużyte, więc zrobiłem mocowania tak prosto, jak się dało 🙂 Tryb dałem po to, aby cały czas utrzymywał linę napiętą. Najpierw coś lżejszego, silnik z przekładnią. Waga to około 60 kg. I coś cięższego. Podajnik ważący ok 140 kg. Ta konstrukcja powinna poradzić sobie z ciężarem 200 kg, […]

Read More

Grease fitting cleaner – Kubota L3800 Tractor Maintenance Quick Tip

Grease Fitting Cleaner – DIYTractor Maintenance Tip All right if you’ve got a tractor and you’ve got a loader arm I guarantee you that you have some recessed zerk fittings you notice I’ve got a clean one and a dirty one and what’s the best and easiest way to clean those fittings? I was inspired […]

Read More

How to Remove a Stripped Bolt or Nut in Your Car

one, two, three, four! Rev up your engines! It’s time for the Scotty Kilmer Channel don’t you just hate it when you have rounded off nuts that you can’t get off, it’s really annoying when that happens, they get so rounded off and you put a socket on them, all it does is slip and […]

Read More

Lawn Mower – Air Filter Replacement

Remove the two screws as seen, in order to open the air filter housing. Remove and discard the old filter element. Clean the area from dust and debris. Make sure to cover the hole, so no dirt can enter the carburetor. This is the new filter element. This is the pre filter. It comes as […]

Read More